Here is the twiggy necklace organiser, or the rustic jewellery display shelf, or, well, I don't really have a name for it but here it is:
We've needed something to help organise our jewellery for a while and I've seen things similar to this online so when we had to give our big hazel a trim last month I kept a branch or two aside with this in mind.
Here's the how to:
Collect your sticks! You need a larger piece for the base (mine was about 1.5" thick and 18" long) and a selection of smaller twigs that will become the hooks.
Take a good look at your smaller twigs. Ideally they will all be a similar width. You'll need to have access to a drill bit suitable for wood that is almost exactly the same size as them. If you can't find a precise match then go for one that is ever so slightly smaller. Too big and your twigs will just fall right out the holes (unless you use a ton of wood glue).
Drill holes at a slight angle at intervals all along your base stick. You need the same number of holes as you have twigs, surprisingly enough. Each hole should go about half an inch deep into your base stick.
At each end of your stick you need to drill the holes that you will use to secure your hanging rail to the wall when it's finished. These need to be drilled stright through the base stick, not at an angle, and they need to go all the way through. (I forgot to photograph them, but you basically need one hole at each end, about 1" in.)
Once all your holes have been drilled, push the twigs into all of them apart from the ones for hanging at each end. They should be quite a snug fit. If they are loose, you might need to use some wood glue to secure them. If any of your twigs are too large to fit in the holes then you can whittle a little off the end to make them fit.
Once all your holes are filled with twigs, and glued should you feel the need, you're all done!
To hang (again, I didn't photograph this part) simply screw a screw through each of the holes you left at the ends until they protrude slightly out the back of the stick. Press the completed hanger against the wall, hard enough that the screw tips leave slight indentations in the wall. Use these as guides to drill into the wall using whatever drill bit is appropriate for your wall type and insert the right kind of plugs before screwing the hanging screws into the wall. If you're hanging it directly onto wood you can just screw straight into it.
And there you have it. One jewellery hanger that looks great, is completely free and took less than an hour to create.